Mostec Swiss Electronics Custom Electronics min

Alarm unit type M3118

  • 2 alarm contacts
  • Input: voltage & current or temperature, special conversions
  • 4 digit LCD display, 15mm, color adjustable, optional: 5 digit
  • programmable by computer or laptop with programming unit
  • buttons to change the alarm contacts
  • universal supply 20...253VAC or DC, galvanic isolated
  • optional signal output (current or voltage), galvanic isolated
  • modbus (optional)
  • USB - logger (optional)
  • optical alarm contact
  • rail mounting 35mm
Operating Instructions
Data Sheet
Certificate
Modbus user guide
Software to configure and program the M3118 series.

Product Details: Alarm unit type M3118

The alarm unit M3118 is used to check or control any type of signal current or voltage. It converts the input signal to an internal standard signal of for example 0 to 100.0%. In this range two alarm contacts can be set independently.

The 4-digit measuring value, as well as the status of the alarm contacts, is shown on an easy to read LCD-Display.

All settings as alarm values, hysteresis, range and operating mode of the floating contacts can be set with a link cable, connected to a personal computer or a laptop. Both limit values can also be changed directly on the device using push buttons.

A typical application would be to measure and monitor pressure in a process vessel. The pressure transmitter converts the pressure of 1 to 10 bar to a current signal of 4 to 20mA. The M3118 monitors under and overpressure in the vessel. It converts the 4... 20mA signal current to 1.00bar...10.00bar. The alarm contacts can be set between 1bar and 10bar. With these floating alarm contacts, overpressure valves, compressors, etc. are driven directly.

Optionally, a galvanic isolated output signal of 0...20mA or 4...20mA is available.

The alarm unit M3118 uses a universal supply from 20 to 253VAC/DC.